Explosion-proof high-energy ignition parameter and matters needing attention
12 explosion-proof high-energy ignition, mainly used in industrial automatic burner ignition fuel gas, fuel oil, tossing the torch ignition, has the advantages of long life and reliable ignition, high temperature resistance, resistance to coking ignition end, self-purification ability, therefore they are widely used in petroleum, chemical industry, environmental protection, energy, metallurgy, ceramics and other industries.
Specific parameters below the power supply voltage 220 v + 10% for 50/60 hz to adapt to the fuel gas, light oil, heavy oil ignition is 1300 ℃ maximum instantaneous heat resistance ignition frequency 6 ~ 12 times 12 j/S spark energy explosive-proof grade BT6 note: 1, before the ignition must ensure furnace purging completed without residual combustible gas.
To prevent safety accidents by started ignition cause explosion.
2, ignition, should first open ignition device, then the injection (
3, ignition is used in the fuel ignition, fuel should be good atomization, atomization effect when the poor quality ignition success rate.
Upon the completion of the ignition, must use the propeller or manual ignition rod out of the flame combustion zone, to ensure the service life of the ignition rod.
4, when the ignition when ignited fuel, namely the breakpoint firearm.
In order to avoid long time continuous ignition lead to internal components burn out, inside the igniter has added protection module, a continuous firing 10 seconds, will automatically stop the ignition output, in situ ignition button again or to connect remote drive restores the ignition.
5, installation and use of ignition rod cannot fall touch, prevent ignition pole insulation porcelain fracture, high pressure leakage, not lighter consequences, seriously affect the safe and normal operation of equipment.
Note: in addition to the wiring according to the instructions, in use process does not recommend the customer to open the ignition housing.
If there are any abnormal situation, please contact our after-sales technical personnel