A, high-energy ignition configuration and the selection of high energy ignition device by high-energy ignition, firing gun, ignition cable of three parts, can be directly used to ignite gas, liquefied petroleum gas, diesel, kerosene, crude oil, residual oil, etc.
High energy ignition device is according to different applications, different light medium selection of different models, so as to save cost, also can achieve ignition effect you want.
If you choose to not appropriate, ignition cable length is too long, can affect lighter effect, the number of ignition is increasing, longer than using rules, will affect the service life of the device.
Two, use method 1, a set of relatively high energy ignition, ignition rod, is the most easy to bad for internal use ceramic parts, so can't fall, don't often landed in the process of using firing gun to clean up the ignition end, production of high-energy firing gun, ignition end resistance to carbon deposition, in the case of carbon deposit can be lighter;
2, high energy ignition when not connected to cable, firing gun, not electricity, otherwise it will damage;
3, high-energy ignition some devices are operated at high load, should strictly obey the rules of working cycle;
4, high-energy ignition of maintenance should be carried out after the cut off power supply for 5 minutes (
Ensure that the surplus electric charge through a discharge resistor capacitor discharge is completed)
5, high-energy ignition during outage for a long time, must cut off power supply system.