High-energy ignition is mainly used in industrial kiln, boiler, chemical waste, such as the need for ignition coking mills exhaust gas ignition, by the high energy ignition, ignition rod, ignition cable of three parts.
Using capacitor energy storage, ignition energy, semiconductor ignition electric nozzle, have very strong self-cleaning ability, is not affected by atmosphere pollution, oil resistance, water resistance, resistance to coking, high temperature resistance.
Working principle: using 220 v, 50 hz alternating current (ac), through the voltage step-up transformer reach higher than 2500 v, after rectification for energy storage capacitor charging, the charging voltage exceeds the breakdown voltage of discharge tube, the voltage on the accumulator by discharge tube by ignition cable and conductive rod, discharge of semiconductor igniter igniter poles are a peak under the action of high voltage pulse energy, so in the semiconductor surface will produce strong electric spark, as a flaming fire.
High energy ignition device consist of igniter, firing gun and shielded cable.
Ac 220 v or 110 v power frequency, by boosting rectifier transform into dc current ripple, the storage capacitor charging.
Electricity flows through the tube when the capacitor is full, discharge, choke, shielded cable transmission to firing gun semiconductor igniter, form a high-energy electric spark.
When the ignition device to stop working, the rest of the charge on the capacitor discharge through the discharge resistance.
When using high energy ignition: 1, the high energy ignition when not connected to cable, firing gun, do not electricity.
Otherwise it will damage the device;
2, must check before using high energy ignition, the device should be connected correctly, reliable contact, firing gun ignitor end into fuel area from 100 to 200 mm;
3, high-energy ignition some devices are operated at high load, should strictly abide by the working cycle;
4, high-energy ignition during downtime for a long time, must cut off power system;
5, high-energy ignition of maintenance should be carried out after the cut off power supply for 5 minutes.