High-energy ignition mainly adopts capacitor energy storage principle of discharge, the power frequency power supply through the booster, after rectification for 2500 v dc to high energy storage capacitor charging.
Using gas discharge tube to control switch components, high-voltage breakdown on the capacitor discharge tube, fast ignitor for semiconductors discharge, pulsed arc.
Working principle: by means of a step-up transformer voltage increases, the power supply after rectification, the energy storage capacitor energy storage, when the voltage on dc capacitor reaches are connected with the breakdown voltage of discharge tube, energy storage capacitor on the voltage and discharge tube breakdown and discharge tube connected electric nozzle, send edm on electric tip clearance, ignite combustible gas mixture.
Failure phenomenon and rule out: failure phenomenon: igniter and light cable joint cause analysis: igniter adverse elimination method: contact with the cable connect a prison corresponding parts fault phenomenon: ignition misfire cause analysis: 1, 2, cable system not plug in contact with the ignition or firing gun bad 3, cable short circuit or open circuit 4, firing gun damage, damage to the igniter, elimination method: 1, 2, input, check the power on the corresponding parts 3 four, replacement, replacement cable musket 5, change the igniter use notice: 1.
Ignition, should first open ignition device, then the injection (
Ignition, general ignition time can't more than 30 seconds.
Ignition, combustion little wind, fire and then gradually increase combustion-supporting wind.
Fuel should be good atomization, atomization effect when the poor quality ignition success rate.
Ignition device for 30 seconds, should be 1 minutes rest again, avoid the continuous use for a long time.
Professional engaged in the r&d and production of high energy ignition.